420

Polyester option for windsurf downhauls and outhauls, grips well in cleats and provides good abrasion resistance

The boxes with the pulley allen are available with ball bearings or normal, the choice between material pulley, acetal resin, die-cast aluminium of high quality or stainless steel high load. They are suited to all types of systems, halyards, systems, line of command and general handling. The range of Low-profile includes the unique cage and retainer Allen designed to deal with high loads of modern facilities.

The lock pulleys A4808 high voltage has a function of opening rotation for better access when changing halyards, etc

Slats stems in mylar for classes such as 420 or 470. The set consists of the right length to replace the slats. € 15.00

Mylar stem lamellas for classes such as 420 or 470 (indicated on nautical boats). The set consists of the right size to replace the slats.

L-shaped trapeze handle

Made of durable nylon and abrasion-resistant for minimum weight and corrosion resistance. The design of the beak snap allows attachment to the loop polar without having to manually open the bolt. The point of attachment to the release lines of the pins.

Handle harness

Clamcleat CL230 choke in anodized aluminum. Suitable for dinghies or dinghies such as 420, 470, 29er, 49er for trapeze adjustment.

Choke of the Clamcleat CL253 in alloy. Suitable for dinghies or dinghies such as 420, 470, 29er, 49er for trapeze adjustment.

Elastico per derive colore giallo

The Super Dinghy Sheet from FSE Robline is ideal for use in single-handed dinghies and all applications where a low weight matters.  It is the sheet for sailors looking for a durable cover with minimal water absorption and low kinking tendency.

Instead of the burber are used these hooks to hook the top of the spinnaker above the wind after the gybe.

Pivot stick

This releasable rubber joint / swivel for tiller extionsions is mounted with an aluminium pin only. The pin is kept in place by a piece of heat shrinkable tubing. To remove a joint : simply cut off the tubing and push the pin out. The joint incorporates a fibre core molded up in the centre. The fibre core will avoid complete failure should the rubber tear which allows you to finish the race. The distance between the mounting hole centers is 32 mm.