Accessories helm

Joint extension bar rudder

Universal joint extension bar rudder round (Ø 12/16 mm). Center hole base 38mm. Ø holes 4 mm

Universal joint extension bar drawbar flat (10 to 14 mm). Center hole base 38mm. Ø holes 4 mm

Joint for extension bar drawbar flat (10 to 14 mm). Center hole base 38mm. Ø holes 4 mm

Agugliotto female or femminella for rudder width 12mm, hole Ø8mm. A: 12 mm S: 12mm D: 5mm L: 75mm And 8mm

Agugliotto female or femminella for rudder width 16mm with a hole of Ø8mm. A: 12mm S: 16mm D: 5mm L: 103mm E: 8mm

Agugliotto female or femminella for rudder width 25mm with hole Ø8mm. A: 13mm S: 25mm D: 5mm, L: 130mm E: 10mm

Agugliotto to drawbar with pin Ø8mm. I: 50mm D: 8mm C: 5mm, T: 20mm B: 18mm F: 31mm

Agugliotto female or femminella for rudder width 12mm, hole Ø8mm. A: 12 mm S: 12mm D: 5mm L: 108mm E: 8mm

Agugliotto female or femminella for rudder width 16mm with a hole of Ø8mm. A: 12mm S: 16mm D: 5mm L: 136mm E: 8mm

Pivot stick

This releasable rubber joint / swivel for tiller extionsions is mounted with an aluminium pin only. The pin is kept in place by a piece of heat shrinkable tubing. To remove a joint : simply cut off the tubing and push the pin out. The joint incorporates a fibre core molded up in the centre. The fibre core will avoid complete failure should the rubber tear which allows you to finish the race. The distance between the mounting hole centers is 32 mm.